Search Results

You are looking at 1 - 10 of 59 items for

  • Author or Editor: Eric d'Asaro x
  • Refine by Access: Content accessible to me x
Clear All Modify Search
Eric D’Asaro

Abstract

Pressure gradient measurements on a subsurface Lagrangian float are used to measure the spectrum of surface waves for 100 days of measurements at Ocean Weather Station Papa. Along Lagrangian trajectories of surface waves, the pressure is constant and the vertical pressure gradient fluctuations equal the Eulerian fluctuations at the mean float depth to second order in wave height. Measurement of the pressure difference between the top and the bottom of the float can thus be used to measure the waves. Corrections for the wave decay with depth, for the vertical motion of the float, for the finite sampling interval, and for the sampling noise (among others) are necessary to obtain accurate results. With these corrections, scalar spectra accurately match those from a nearby Waverider buoy for significant wave heights greater than about 3 m. For smaller wave heights, noise in the pressure measurements biases the float spectral measurements. Significant wave height is measured with an rms error of 0.37 m over the measured range of 1–9 m. This demonstrates that Lagrangian floats accurately follow the Lagrangian trajectories of surface waves. More detailed and quieter measurements of float motion could likely measure directional wave spectra from below the surface. Similar methods could be used to infer surface wave properties from other subsurface vehicles.

Full access
Eric D'Asaro

Abstract

Velocity measurements in the outer part of the bottom boundary layer on the Hatteras Abyssal Plain are examined for indicators of boundary-layer turbulence. Velocity fluctuations in two frequency bands, near-inertial and high-frequency (1–4 cph), display mixed-layer signatures. The high-frequency velocities measure primarily boundary-layer turbulence. The turbulence, so measured, is modulated on inertial and tidal time scales and extends intermittently to the mixed layer top. The near-inertial velocities are less energetic within the mixed layer than above and, for the dominant clockwise component, the mixed layer leads the interior. Following D'Asaro (1982), this is attributed to turbulent stresses which, consequently, must fill the mixed layer. These observations suggest that the entire bottom mixed layer is at least inter-mittently turbulent.

Full access
Eric D'Asaro

Abstract

The interaction of near-inertial velocities with the benthic boundary layer above a flat bottom is investigated using a diagnostic model and a 3-month time series of velocity from a fixed array of current meters. The observed near-inertial motions are assumed to be due to internal waves and diurnal tides. If the vertical wavelength of the internal waves is much larger than the boundary-layer thickness, the turbulent stresses acting on the near-inertial motions and the work done by the stresses on these motions can be computed. The boundary layer is estimated to absorb –0.003 to 0.024 erg cm−2 s−1 from the near-inertial motions, with one-third coming from the K1 diurnal tide and the rest from the internal-wave field. This is far less than estimated by Leaman (1976) and suggests that the benthic boundary layer on a flat bottom plays a minor role in dissipating internal-wave energy. This is also much less than the total energy dissipation in the boundary layer, suggesting that the boundary layer is primarily driven by low-frequency motions, not internal waves. A simple slab model with a linearized quadratic drag law qualitatively explains the observed near-inertial velocity structure and energy flux.

Full access
Eric A. D'Asaro

Abstract

Modern surface drifters tracked by Argos are an attractive method for measuring the spatial structure of near-surface currents. This note discusses the accuracy to which velocity can be estimated from such data, assuming perfect drifters. The analysis concentrates on data from OCEAN STORMS centered at 47.5°N in the eastern North Pacific, a region of low mesoscale activity. The irregular, but nearly diurnally repeating, pattern of fixes leads to leakage between near-inertial (1.48 cpd) and subinertial (0.5 cpd) frequencies. Total spectral leakage for a naive spline interpolant of the fixes is about 2×10−3 in energy, or 5% in amplitude. Other interpolants can produce an order of magnitude more leakage. An algorithm that controls these errors is described. Only an inertial peak and frequencies well below 0.5 cpd can be resolved. The remaining noise can be described as the sum of a random fix error of 600 m rms and unresolved subinertial velocities with an rms displacement of about 550 m. The errors in the computed inertial and low-frequency velocities are 0.03 and 0.01 m s−1, respectively. These can be reduced with further time averaging. Significantly better estimates of velocities would require both more accurate and more frequent position fixes.

Full access
Eric A. D'Asaro

Abstract

The ability of neutrally buoyant, high-drag floats to measure the air–sea heat flux from within the turbulent oceanic boundary layer is investigated using float data from four different winter and fall float deployments. Two flux estimates can be made: Q 0A measures the vertical advection of heat, and Q 0D integrates the Lagrangian heating rate. Because the floats are only imperfectly Lagrangian, a key issue is diagnosing the ability of a given set of float data to make accurate flux measurements. A variety of diagnostics are explored and evaluated. Here Q 0A and Q 0D are compared to heat flux measurements computed using bulk formulas and shipboard measurements for one 2-week cruise. Quality controlled float-based fluxes agree with bulk fluxes to within 10 W m−2 for both positive and negative values. The differences are well within the expected statistical errors in the float measurements and the bias errors of the bulk measurements.

Full access
Eric A. D’Asaro

Abstract

Advances in low-power instrumentation and communications now often make energy storage the limiting factor for long-term autonomous oceanographic measurements. Recent advances in photovoltaic cells, with efficiencies now close to 30%, make solar power potentially viable even for vehicles such as floats that only surface intermittently. A simple application, the development of a solar-powered Argos recovery beacon, is described here to illustrate the technology. The 65-cm2 solar array, submersible to at least 750 dbar, powers an Argos beacon. Tests indicate that with minor improvements the beacon will run indefinitely at any latitude equatorward of about 50°. Scaling up this design to current operational profiling floats, each profile could easily be powered by a few hours of solar charging, a shorter time than is currently being used for Argos data communications.

Full access
Eric A. D'Asaro

Abstract

A truly Lagrangian float would follow all three components of oceanic velocity on all timescales. Progress toward this goal is reviewed by analyzing the performance of nearly Lagrangian floats deployed in a variety of oceanic flows. Two new float types, described in this paper, are autonomous with durations of months, can alternate between Lagrangian and profiling modes, relay data via satellite, and can carry a variety of sensors. A novel hull design is light, strong, and has a compressibility close to that of seawater.

The key to making floats accurately Lagrangian is an improved understanding of the factors that control float buoyancy and motion. Several insights are presented here. Anodized aluminum gains weight in seawater due to reactions between its surface and seawater. At low pressure the buoyancy of floats with O-ring seals varies as if attached bubbles of air were being compressed. The volume of “air” decays exponentially with a decay scale of a few days from 10 to 30 cc at deployment to an asymptotic value that depends on pressure. The drag of floats moving slowly through a stratified ocean is dominated by internal wave generation and is thus linear, not quadratic. Internal wave drag acting on an isopycnal-seeking float will cause the float to be Lagrangian for frequencies greater than about N/30, where N is the buoyancy frequency.

These floats have proven most useful in measuring the turbulence in ocean boundary layers and other regions of strong turbulence where the ability of the floats to be Lagrangian on short timescales matches the short timescale of the processes and where the size of the turbulent eddies exceeds the size of the float. On longer timescales, the floats successfully operate as isopycnal followers. Because truly Lagrangian floats are highly sensitive to minor perturbations, extension of the frequency band over which the floats are Lagrangian will require careful control of float buoyancy and thus a detailed understanding of the float's equation of state.

Full access
Eric A. D'Asaro

Abstract

Upper ocean currents and temperature in the northeastern Pacific were measured during a 14-day period in November 1980 as part of STREX. Velocities in the upper ocean are dominated by near-inertial frequency oscillations. Thew oscillations are modified by wind stress variations associated with the passage of a strong cold front. The change in the inertial currents both in the mixed layer and below is qualitatively consistent with linear internal wave dynamics if turbulent stresses during the storm are assumed to extend 10–20 m below the mixed layer.

The ratio of mean squared buoyancy frequency N 2 and mean squared shear S 2 computed over a 10 m interval defines an average Richardson number R 0=N 2/S 2; R 0 is approximately 2.5 except in regions of high inertial shear. In particular, values as low as 0.7 are obtained in a 20 m thick region immediately below the base of the mixed layer. The data are consistent with a model of the oecanic shear field consisting of a background shear, corresponding to a value of R 0=2.5, plus a variable inertial frequency shear field. Variations in R 0, and by implication the rate of mixing, are due primarily to variations in the inertial frequency shear.

The mixed layer deepened 3–5 m during the 15 November storm. The temperature profiles suggest that mixing due to the storm extended roughly 5 m below the mixed layer. The mixed layer model of Niiler successfully models the observed response of the mixed layer. The amount of deepening is sensitive to the preexisting inertial currents during the storm passage. Using this model the amount of deepening could have been up to 80% greater than observed, if the storm had occurred earlier in the measurements, when the preexisting inertial currents were larger.

Full access
Eric A. D'Asaro

Abstract

Time series of wind stress computed from long-term meteorological buoy data off North America are used to examine the forcing of surface inertial currents by the wind. A simple damped slab model of the mixed layer is used to compute 〈Π(H)〉, the average flux of energy from the wind to mixed layer inertial currents in a mixed layer of fixed depth H. The forcing of mixed layer inertial motions is highly intermittent. Most of the forcing occurs during the winter months, with a few dozen events accounting for typically over half the total energy flux. Major forcing events are usually associated with translating cold fronts or small lows with scales of about 100 km. The larger, synoptic scale features have little energy at the inertial frequency and thus result in only weak forcing of inertial currents. A strong seasonal signal exists in the inertial forcing. At OWS-P (50°N, 145°W), 〈Π(50 m)〉 is largest from October to February and is a factor of 12 above the June and July values. If seasonally varying mixed layer depths are used, 〈Π(H)〉 is largest in October, due to the combination of a shallow mixed layer and strong forcing. The forcing of inertial motions varies with location, although comprehensive geographical coverage is not obtained here. In these data the 1~ wintertime average 〈Π(50 m)〉 is found off the east coast of North America at about 35°N. The smallest value, in the Gulf of Mexico, is four times less. Although a strong correlation between 〈Π(50 m)〉 and 〈u *3〉 the parameterized flux of energy to mixed layer turbulence, is found at OWS-P, this correlation does not hold at all other locations. This suggests that climatological models that attempt to parameterize 〈Π〉 in terms of 〈u *3〉 will need to be tuned to local conditions.

Full access
Eric A. D'Asaro

Abstract

The three-dimensional structure of the near-inertial frequency internal wave field was measured at two open ocean sites using expendable velocity profilers. Both wave fields appear to be dominantly wind forced although their vertical structure and horizontal scales are quite different. The HYDRO-79 data were taken in the Sargasso Sea in September 1979. The internal wave field is predominantly downward propagating and vertically uniform, when WKB scaled, in the upper 800 m of the ocean. The energy density is roughly equal to Munk's (1981) universal value. The STKEX data were taken during a period of strong storms in the northeastern Pacific Ocean in November 1980. In the upper few hundred meters the wave field is five times larger horizontally and five times more energetic, when WKB scaled, than the HYDRO-79 wave field. Measurements made after the passage of a strong cold front show an even more energetic and larger scale wave field extending to 500 m. Comparison with the simulations of Price (1983a,b) suggests that this change may be due to the generation of near-inertial frequency internal waves by the wind stress variation associated with the cold front.

Full access