Abstract

A physically based ground hydrology model is developed to improve the land-surface sensible and latent heat calculations in global climate models (GCMs). The processes of transpiration, evaporation from intercepted precipitation and dew, evaporation from bare soil, infiltration, soil water flow, and runoff are explicitly included in the model. The amount of detail in the hydrologic calculations is restricted to a level appropriate for use in a GCM, but each of the aforementioned processes is modeled on the basis of the underlying physical principles. Data from the Goddard Institute for Space Studies (GISS) GCM are used as inputs for off-line tests of the ground hydrology model in four 8° × 10° regions (Brazil, Sahel, Sahara, and India). Soil and vegetation input parameters are calculated as area-weighted means over the 8° × 10° gridhox. This compositing procedure is tested by comparing resulting hydrological quantities to ground hydrology model calculations performed on the 1° × 1° cells which comprise the 8° × 10° gridbox. Results show that the compositing procedure works well except in the Sahel where lower soil water levels and a heterogeneous land surface produce more variability in hydrological quantities, indicating that a resolution better than 8° × 10° is needed for that region. Modeled annual and diurnal hydrological cycles compare well with observations for Brazil, where real world data are available. The sensitivity of the ground hydrology model to several of its input parameters was tested; it was found to be most sensitive to the fraction of land covered by vegetation and least sensitive to the soil hydraulic conductivity and matric potential.

Abstract

This paper describes a time-sensitive approach to climate change projections that was developed as part of New York City’s climate change adaptation process and that has provided decision support to stakeholders from 40 agencies, regional planning associations, and private companies. The approach optimizes production of projections given constraints faced by decision makers as they incorporate climate change into long-term planning and policy. New York City stakeholders, who are well versed in risk management, helped to preselect the climate variables most likely to impact urban infrastructure and requested a projection range rather than a single “most likely” outcome. The climate projections approach is transferable to other regions and is consistent with broader efforts to provide climate services, including impact, vulnerability, and adaptation information. The approach uses 16 GCMs and three emissions scenarios to calculate monthly change factors based on 30-yr average future time slices relative to a 30-yr model baseline. Projecting these model mean changes onto observed station data for New York City yields dramatic changes in the frequency of extreme events such as coastal flooding and dangerous heat events. On the basis of these methods, the current 1-in-10-year coastal flood is projected to occur more than once every 3 years by the end of the century and heat events are projected to approximately triple in frequency. These frequency changes are of sufficient magnitude to merit consideration in long-term adaptation planning, even though the precise changes in extreme-event frequency are highly uncertain.

Abstract

In the Project for Intercomparison of Land-Surface Parameterization Schemes phase 2a experiment, meteorological data for the year 1987 from Cabauw, the Netherlands, were used as inputs to 23 land-surface flux schemes designed for use in climate and weather models. Schemes were evaluated by comparing their outputs with long-term measurements of surface sensible heat fluxes into the atmosphere and the ground, and of upward longwave radiation and total net radiative fluxes, and also comparing them with latent heat fluxes derived from a surface energy balance. Tuning of schemes by use of the observed flux data was not permitted. On an annual basis, the predicted surface radiative temperature exhibits a range of 2 K across schemes, consistent with the range of about 10 W m⁻² in predicted surface net radiation. Most modeled values of monthly net radiation differ from the observations by less than the estimated maximum monthly observational error (±10 W m⁻²). However, modeled radiative surface temperature appears to have a systematic positive bias in most schemes; this might be explained by an error in assumed emissivity and by models’ neglect of canopy thermal heterogeneity. Annual means of sensible and latent heat fluxes, into which net radiation is partitioned, have ranges across schemes of30 W m⁻² and 25 W m⁻², respectively. Annual totals of evapotranspiration and runoff, into which the precipitation is partitioned, both have ranges of 315 mm. These ranges in annual heat and water fluxes were approximately halved upon exclusion of the three schemes that have no stomatal resistance under non-water-stressed conditions. Many schemes tend to underestimate latent heat flux and overestimate sensible heat flux in summer, with a reverse tendency in winter. For six schemes, root-mean-square deviations of predictions from monthly observations are less than the estimated upper bounds on observation errors (5 W m⁻² for sensible heat flux and 10 W m⁻² for latent heat flux). Actual runoff at the site is believed to be dominated by vertical drainage to groundwater, but several schemes produced significant amounts of runoff as overland flow or interflow. There is a range across schemes of 184 mm (40% of total pore volume) in the simulated annual mean root-zone soil moisture. Unfortunately, no measurements of soil moisture were available for model evaluation. A theoretical analysis suggested that differences in boundary conditions used in various schemes are not sufficient to explain the large variance in soil moisture. However, many of the extreme values of soil moisture could be explained in terms of the particulars of experimental setup or excessive evapotranspiration.

This paper provides a synthesis of results that have emerged from recent modeling studies of the potential sensitivity of U.S. regional ozone (O₃) concentrations to global climate change (ca. 2050). This research has been carried out under the auspices of an ongoing U.S. Environmental Protection Agency (EPA) assessment effort to increase scientific understanding of the multiple complex interactions among climate, emissions, atmospheric chemistry, and air quality. The ultimate goal is to enhance the ability of air quality managers to consider global change in their decisions through improved characterization of the potential effects of global change on air quality, including O₃ The results discussed here are interim, representing the first phase of the EPA assessment. The aim in this first phase was to consider the effects of climate change alone on air quality, without accompanying changes in anthropogenic emissions of precursor pollutants. Across all of the modeling experiments carried out by the different groups, simulated global climate change causes increases of a few to several parts per billion (ppb) in summertime mean maximum daily 8-h average O₃ concentrations over substantial regions of the country. The different modeling experiments in general do not, however, simulate the same regional patterns of change. These differences seem to result largely from variations in the simulated patterns of changes in key meteorological drivers, such as temperature and surface insolation. How isoprene nitrate chemistry is represented in the different modeling systems is an additional critical factor in the simulated O₃ response to climate change.

Abstract

In the PILPS Phase 2a experiment, 23 land-surface schemes were compared in an off-line control experiment using observed meteorological data from Cabauw, the Netherlands. Two simple sensitivity experiments were also undertaken in which the observed surface air temperature was artificially increased or decreased by 2 K while all other factors remained as observed. On the annual timescale, all schemes show similar responses to these perturbations in latent, sensible heat flux, and other key variables. For the 2-K increase in temperature, surface temperatures and latent heat fluxes all increase while net radiation, sensible heat fluxes, and soil moistures all decrease. The results are reversed for a 2-K temperature decrease. The changes in sensible heat fluxes and, especially, the changes in the latent heat fluxes are not linearly related to the change of temperature. Theoretically, the nonlinear relationship between air temperature and the latent heat flux is evident and due to the convex relationship between air temperature and saturation vapor pressure. A simple test shows that, the effect of the change of air temperature on the atmospheric stratification aside, this nonlinear relationship is shown in the form that the increase of the latent heat flux for a 2-K temperature increase is larger than its decrease for a 2-K temperature decrease. However, the results from the Cabauw sensitivity experiments show that the increase of the latent heat flux in the +2-K experiment is smaller than the decrease of the latent heat flux in the −2-K experiment (we refer to this as the asymmetry). The analysis in this paper shows that this inconsistency between the theoretical relationship and the Cabauw sensitivity experiments results (or the asymmetry) is due to (i) the involvement of the β _g formulation, which is a function of a series stress factors that limited the evaporation and whose values change in the ±2-K experiments, leading to strong modifications of the latent heat flux; (ii) the change of the drag coefficient induced by the changes in stratification due to the imposed air temperature changes (±2 K) in parameterizations of latent heat flux common in current land-surface schemes. Among all stress factors involved in the β _g formulation, the soil moisture stress in the +2-K experiment induced by the increased evaporation is the main factor that contributes to the asymmetry.