New York City, New York (NYC), is extremely vulnerable to coastal flooding; thus, verification and improvements in storm surge models are needed in order to protect both life and property. This paper highlights the Stony Brook Storm Surge (SBSS) modeling system. It utilizes surface winds and sea level pressures from the fifth-generation Pennsylvania State University (PSU)-National Center for Atmospheric Research (NCAR) Mesoscale Model (MM5) or the Weather Research and Forecasting (WRF) model to drive the Advanced Circulation Model for Coastal Ocean Hydrodynamics (ADCIRC). For this study, the MM5 is utilized at 12-km grid spacing and ADCIRC is run on an unstructured grid down to ~10-m resolution in areas around Long Island and NYC.
This paper describes the SBSS and its performance across the NYC region during the 11–12 December 1992 nor'easter and Tropical Storm Floyd on 16–17 September 1999. During the 1992 event, east-northeasterly surface winds of 15–25 m s−1 (30–50 kts) persisted for nearly 24 h, while hurricane-force winds (35–40 m s−1) occurred for a few hours just south of western Long Island. This created a 1.0–1.5-m storm surge around NYC and western Long Island Sound over three tidal cycles. ADCIRC successfully simulated the peak water levels to within ~10%, and it realistically simulated some of the flooding across lower Manhattan. The surface winds for Tropical Storm Floyd were only 5–10 m s−1 weaker than the 1992 event, but no coastal flooding occurred during Floyd, because the storm approached during a low tide. Additional Floyd simulations were completed by shifting the storm's landfall to the spring high tide the previous week, and by doubling the wind speed to mimic a category-1 hurricane. A combination of the spring high tide and a category-1 hurricane scenario during Floyd would have resulted in moderate flooding at several locations around NYC.
Storm Surge Research Group, School of Marine and Atmospheric Sciences, Stony Brook University, Stony Brook, New York
